Antique Metal

Antique Metal

July 17, 2005

Antique Metal

I have to rewire an old lamp metal corners very difficult to get the thread going through the curves?

ideas about how get the thread to travel safely. I thought Using a chain to pull its goals tight area, and I'm worried that the node would withdrawn. View an example as my notes from the brass lamp becomes the cable must travel through, so you can connect the bulb holder. http://www.sana.com/assets_ebay/lamptypecopy.jpg

Hopefully you have removed the old cable yet. Just pull the cable to both old and new 1 or 1 1 / 2 inches, the wind son together and pull the cable through. Other wise check to see if the tubes are a screw base. Please, try this: Wad a piece of paper into a ball and made a long thread. Insert the ball and the wire at one end of the tube and blow into the tube. Push a wire in the tube and blow again. Continue to grow and play in the wire to the bundle of paper that you can fish from the other end. Then attach a rope to pull the wire and take the new through.Then wire, a loop in the wire is attached to the chain and pull through. Helping to push the cable in the same time.

Trash Treasury at the age of recycling and reuse, the adage "waste of one is a treasure Another man, "says as much about saving and then as now - only now with greater urgency.